Main ECU grounds. E1 is usually the case ground, while E2 is the sensor ground. 2. Engine Vital Sensors
Disclaimer: Always refer to the factory Toyota EWD for your specific chassis year and market (JDM, Europe, General). The above pinout is based on common 1KZ-TE ECUs (1993–2002) and should be verified with a multimeter before cutting wires. 1kz ecu pinout
Check pin A18 (EDU) or C11 (FC) . If the fuel cut solenoid loses ground through the ECU, the engine dies. On many swaps, people bypass this by wiring the fuel cut solenoid directly to the ignition switch (12V), but this prevents the ECU from cutting fuel for anti-run-on. It’s safer to let the ECU control it. Main ECU grounds
| Pin | Wire Color | Signal Name | Function | Voltage / Signal | | :--- | :--- | :--- | :--- | :--- | | | Red/Blue | VTA1 | Throttle Position Sensor (TPS) Signal | 0.5V (Idle) – 4.5V (WOT) | | B2 | Black | E2 | TPS Sensor Ground | 0V | | B3 | Red/Yellow | VC | TPS Reference Voltage (5V output from ECU) | 5V | | B4 | N/A | N/C | Not Connected | - | | B5 | Green/White | THW | Engine Coolant Temp (ECT) Signal | 2.5V (Cold) → 0.3V (Hot) | | B6 | Red/Black | THA | Intake Air Temp (IAT) Signal | 3.0V (Cold) → 1.0V (Hot) | | B7 | Shield | E1 | Sensor Shield Ground (Crank/Cam signals) | 0V | | B8 | White | G2 | Crank Position Sensor – G2 (Ne/Ne+) | AC sine wave (1-5V during crank) | | B9 | Black | G- | Crank Position Sensor – G- (Ne-) | AC sine wave (inverse of G2) | | B10 | N/A | N/C | Not Connected | - | | B11 | N/A | N/C | Not Connected | - | | B12 | Yellow | STA | Starter Signal (crank sense) | 12V (While cranking only) | | B13 | Black/White | NSW | Neutral Start Switch (P/N signal) | 0V (In gear) / 12V (Park/Neutral) | | B14 | Brown/White | A/C1 | AC Switch Signal (to ECU) | 12V (AC ON) | | B15 | N/A | N/C | Not Connected | - | | B16 | Blue | SPD | Vehicle Speed Sensor (VSS) | Pulse (0-12V square wave) | | B17 | Black | E2 | Sensor Common Ground | 0V | | B18 | White/Green | G1 | Cam Position Sensor (G1 – Cylinder 1 TDC) | AC sine wave | | B19 | Red | G2e | Cam Position Sensor (G2 – Cylinder 4 TDC) | AC sine wave | | B20 | N/A | N/C | Not Connected | - | | B21 | N/A | N/C | Not Connected | - | | B22 | Light Green/Red | A/C2 | AC Compressor Clutch Feedback | 12V (Clutch engaged) | Engine Vital Sensors Disclaimer: Always refer to the
Detailed wiring diagrams and technical manuals for specific variations can be found on Scribd's 1KZ-TE Wiring Guide Studocu's Land Cruiser Prado Wiring Are you troubleshooting a specific issue