Добро пожаловать! Для просмотра своих заказов, скидок и отзывов войдите в личный кабинет или зарегистрируйтесь.
|
The V2.1 board often requires specific port/pin settings for the E-Stop to work. In Mach3, go to Config > Ports and Pins > Input Signals and ensure the E-Stop is set to (common for this board). "Device Not Found"
Once the driver is active, you must configure the I/O pins within Mach3 ():
: Obtain the motion driver file, typically named BL-UsbMach-V22.dll or similar.
You will waste 30 minutes and risk infecting your PC.
(if unsigned):
Downloading unverified drivers from third-party sites claiming to offer "bl-usbmach-v2.1" could result in:
The V2.1 board often requires specific port/pin settings for the E-Stop to work. In Mach3, go to Config > Ports and Pins > Input Signals and ensure the E-Stop is set to (common for this board). "Device Not Found"
Once the driver is active, you must configure the I/O pins within Mach3 ():
: Obtain the motion driver file, typically named BL-UsbMach-V22.dll or similar.
You will waste 30 minutes and risk infecting your PC.
(if unsigned):
Downloading unverified drivers from third-party sites claiming to offer "bl-usbmach-v2.1" could result in:
+7 916 5079491
574901006
sales@prdisk.ru 
