Exergear X10 Cross Trainer Manual Better !!top!!

Before using your Exergear X10 Cross Trainer, make sure to:

Use the Tension Control Knob (usually located on the upright mast). Turn it toward "1" for low resistance and "8" (or higher) to increase difficulty. 2. Essential Maintenance ("The Quiet Machine" Tips) Exergear X10 Cross Trainer Manual BETTER

The standard manual shows you where the bolts go. This manual tells you how to survive the process. Before using your Exergear X10 Cross Trainer, make

| Problem | Stock Manual Solution | Solution | | :--- | :--- | :--- | | Clicking noise on right pedal | Tighten pedal strap | Remove pedal, apply blue Loctite to the crank bolt. The factory grease washes out in 3 months. | | Resistance fluctuates | Turn off/on | The reed switch gap is too wide. Open the lower shroud, move the reed switch closer to the magnet (credit card thickness). | | Console turns off mid-workout | Check batteries | The dynamo (self-generator) needs initial spin-up. Pedal backwards for 30 seconds to "jump start" the capacitor. | | "E-2" Error code | Replace batteries | This indicates a resistance calibration loss. Perform the reset in Part 2, then pedal at 60 RPM for 2 minutes. | The factory grease washes out in 3 months